no good playback!!

ovaal_ · Post by **ovaal_** » Thu Sep 27, 2001 13:01

hello!!!good job for resolume
there are all we need but .....not enough faster my pc are a thunderbird 800 mghz with 256 mo and gforce2 mx.i don't have a good playback
with only one vid not very good ,with 3 i can't work!i have try the mideo codec but it's not better. i work with the last indeo codec that's a little more better
and the vid quality increase... i hope that i have made a mistake that's not a hardware probleme .the next ati raedon 7500 will be prehaps greaty for our software this card provided a dualhead too and more faster than a geforce2 ultra!!

ovaal_ · Post by **ovaal_** » Thu Sep 27, 2001 13:57

i work with win98 perhaps that's the reason of my problem (i've read somewhere else thats a great solution

Post by **bart** » Fri Sep 28, 2001 10:35

please render your footage to the avi file format with the Cinepak codec, resolution 320x240 and make every frame a keyframe ... that should fix your speed problems ... Please check our manual, chapter 'Preparing media' for more info ...

ovaal_ · Post by **ovaal_** » Fri Sep 28, 2001 15:05

i have already tryed but i'm not satisfied(too ugly)and not better.i should try with win 2000

Post by **bart** » Sat Sep 29, 2001 13:33

what do you mean with too ugly .. if you set the Quality to 100% it should be ok ...

Sinistra_ · Post by **Sinistra_** » Sat Oct 06, 2001 22:51

The program is pretty damn good, but i canÂ´t use it on my preformances if the speed is worse than on my old 486. I was thinking of increasing my laptop from 255 ram to 512 ram, but if this is a common problem then that simply sucks...

ovaal_ · Post by **ovaal_** » Sat Oct 13, 2001 01:46

i have set the quality at 100 not the best pictures around but not too bad .but i find that s ever a little slow for the playback with only one channel and when we make many overlay that goes more slower ...i must readjust the speed of each chan to have the good tempo with the Music. my config thbd 800 mhz with geforce 2 mx and 256 mo...not too bad???

neil_ · Post by **neil_** » Mon Oct 15, 2001 19:00

Try getting a spare HDD and doing a re-install as I did a Performance using this software and it was great and fast, but as I have used my machine over the weeks since my machine has started to run it slower and slower, but on a fresh install its back to full speed again.

So a clean system is a recommended must/

naren_ · Post by **naren_** » Mon Oct 29, 2001 17:28

Just to check. What is your frame refresh speed? It defaults to 15fps. You need to have it ant at least 30fps..