Resolume Forum

You get creative when you're forced to use ShowCAD Artist as your lighting "board"
It might be ok for small rigs, but not large ones. QLC+ actually handles better

Thank you so much for your several replies.

If so, If I can control the video which you have shown me from one(1) PC.
Do you mean that only 5. 1. 0 version program should be.? Can't I do with 5.0.x Version?

Can I do as the video, if I use method which dirtyjohn_lv & joris told me ?

And method which Oaktown is 5.1.0 version?

How did the video set up? Is it right to do what PC did?

What would I do different if I'm using two separate pcs? One with qlc and the other with resolume version 4.2.0 rev5894? They are networked together already and I wanna be able to have a button in qlc that plays ones of the videos or one of the layers. Thxs!

Follow the same instructions but instead of using the loopback address (127.0.0.1) in QLC+, use the IP address of the computer running Arena.

I've only seen this work with Chamsys as they have a send to applications on this computer option. Could you use Chamsys instead of qlc?

I'm using an entec dmx to usb box and need to set that as the output under mapping. So I can not use artery as the output as indicated on the screenshots on the first page. How can I make it still work?

Anyone?

Lightboymike wrote:I'm using an entec dmx to usb box and need to set that as the output under mapping. So I can not use artery as the output as indicated on the screenshots on the first page. How can I make it still work?

I'm not sure what you're trying to make work and what screenshots you're referring to so can you rephrase your question?

Are you talking about mapping in QLC+? Is artery supposed to read Artnet?