Resolume Forum

Hello,

I'm new on Resolume. I'm trying to use 2 Resolume Arena 4.1.3 on 2 computers (PC-PC and Mac-PC)
I've adjusted OSC setting for them as master an slave.
I open exactly the same compositions, same settings and same videos.
When i do sth on master computer, i can see same things on slave computer. But when i play a video, slave computer shows me playing same video but the Output monitor is blank.
I have attached screen caps.

Your OSC settings look correct. Does the clip play correctly when you trigger it manually, without OSC communication?

When OSC enabled, the slave computer can't play clips both from master computer or manually.
if i disable OSC and restar Resolume, it becomes normal.

To be honest, it looks like there is some effect or layer positioning going on which is causing the output to be black.

What happens when you first run the clip normally, and then enable OSC?

It keeps running, but it turns off when i try to change the clip.

Well, I have good news and bad news.

The good news it's broken for us as well. The bad news is we have no idea what's causing it.

This means that for the time being we're going to have to write it off as broken.

We have to wait to be fixed on ver. 4.1.4

It seems didn't fixed in 4.1.4... I just tested it...

I am using 4.1.7 and out of the blue I cannot get any clip to play in my output preview window. I don't know where to begin troubleshooting it. Opacity is at 100% and there are NO effects being used. What do you suggest I do? The screen capture above is the same thing I see. Blank output but preview clip working below it.

I remember the resolume guys saying that you can't use OSC as a master/Slave because of the black output problem. If that was corrected i'm sure they'll chime in. But my memory says controlling resolume from resolume brings up this issue. Think resolume 5 fixes this.

I've had mixed success using touch designer to drive multiple resolume systems.