Resolume Forum

Hi there is there any way to have the little output preview on an external monitor?
I would find it very helpful when using tripleheads card.

thanks

Alberto

Not presently. Why do you want to the preview on an external monitor?

you can always change the size of the preview by dragging it out to the right.

It would have been helpful on a videomapping projet I just had.
Both during the day (no projection because of sun light) and before or during the shows (production office wasn't close to the projection) having the preview on a big external monitor would have helped to check and modify the show run from external consolle linked smpte with lights and music.
I mean, not to program all the show blind, just to make little modification on the structure of the show as I can see for the lights with a virtual visualizer when sunlight goes up!
Plus I found the preview very well done, with a triplehead the preview was almost the same as the real output with softedge and everything!

you can connect an extra monitor and use the advanced output to show the outputs/layers sliced on the extra monitor