Resolume Forum

Guys, this is so simpe, yet there are a couple of solutions available, so I´d like to hear your comments.

- Cenographic Setup -
6 x 1x1m square panels, suspended by wires placed in a row, with some angles between them.

- Content and Slices -
Content will be movies rendered like an entire single panel stripe 6x1m proportion, divided and mapped by 6 slices.

Content production is no big deal. Mapping is no big deal. The relation about content and frame format IS my concern. Although I am used to work with lower resolutions, usually based on 800x600 with a single common display, I wish to maximize the quality of the projected content.

For instance, If I use a single projector based on 800x600 or 1024x768 frame format, and place my movie stripe on the center of that, there will be such a big loss of pixel area being used, therefore image resolution as well. Are you following me?
I am not sure if I can get a FullHD projector or even being capable of mixing a couple of layers with FullHD content in my MacBookPro.
So, I´d love to hear some suggestions about what could I do to get a better image resolution output.
I own a MTH2G and I can get two projectors for this setup. Would that help?

Any help is appreciatted.

thanks!!

Two projectors would help a lot. Higher resolution and brighter output. Try it and see if your GPU can handle it.