Resolume Forum

hi all,
at my last gig i got 7 LED stripes... 6 of them were skewed... see the photo.
http://szene1.at/event/spring_break_eur ... 1/11396976
it was not possible for me to edit the input area for this setup.
it was also not able to do it on the LED processor.
i did it with ir mapio.
it would be great to edit the points in the input same like in the output area.

cheers

This is indeed not possible using the current output options, but we're working on it

And why does the advanced mapping input (0,0 coordinate makes left corner slice on left corner screen) different from the output (0,0 makes the middle of your slice go on the left corner).

Should be better if the output is the same as the output (makes it easier for pixel mapping).

alfaleader wrote:And why does the advanced mapping input (0,0 coordinate makes left corner slice on left corner screen) different from the output (0,0 makes the middle of your slice go on the left corner).

Should be better if the output is the same as the output (makes it easier for pixel mapping).

PLUS ONE FOR THAT

I just mapped Coachella's sahara tent with resolume and it would have been so much easier if the x,y on both input and output corresponded to upper left corner of the slice...

najrock wrote:

alfaleader wrote:And why does the advanced mapping input (0,0 coordinate makes left corner slice on left corner screen) different from the output (0,0 makes the middle of your slice go on the left corner).

Should be better if the output is the same as the output (makes it easier for pixel mapping).

PLUS ONE FOR THAT

I just mapped Coachella's sahara tent with resolume and it would have been so much easier if the x,y on both input and output corresponded to upper left corner of the slice...

Agreed....would be nice to be at least consistent

Don't care which one as long as they're both the same!