Anchor Points in Advanced Output Mapping
Posted: Sat Feb 01, 2014 15:54
Hi,
In the advanced output section of Arena, the Input tab references the anchor point (xy position) of a slice to the top left, while the output tab uses the middle as anchor. I assume this is so the slices rotate around their centre.
It would be awesome if this could be modified so the anchor point of a slice can be placed in any corner or centre.
Regards, Tom
In the advanced output section of Arena, the Input tab references the anchor point (xy position) of a slice to the top left, while the output tab uses the middle as anchor. I assume this is so the slices rotate around their centre.
It would be awesome if this could be modified so the anchor point of a slice can be placed in any corner or centre.
Regards, Tom