Resolume Forum

Question: does someone here know how to create a pillar shape out of a layer in resolume?
I want a 3D, z-rotating, simple, round pillar/tube kinda shape. (Not talking about mapping). Creating a mask will not result in the effect I want because the video won't 'bend'. I'm pretty sure this must be possible by combining a few effects, I just can't figure out how.
I hope this is understandable because it's kinda hard to explain what I mean exactly


Thank u!

You could try pixels in space with zero extrusion, highest resolution and shape set to cylinder.

thank you, didn't try that yet. Good enough for now!
wish it would be possible without the pixel effects but I think I will have to create that with other software.