Resolume Forum

Hey There,

I was starting to write a post about a problem with the 'continue playback' button in a trimmed clip. It looked like it did not continue playback after i adjusted the in and out points.. But now.. after 15 minutes all of a sudden it does. Now I tried another clip but the same problem occurs . Does it need time to load? or did i accidentally clicked on something and i did not notice?

Thanks for reporting this Noralie! I just tried and indeed continue is not working on clips with in and out-points

Unfortunately we can't fix this anymore in the upcoming 4.2.0 release but it will be part of 4.2.1.

Well it does work but it needs a bit of time to load or something..' cuz after 10 minutes it DID work.. but i don't get why it takes that long.

hmm now I tried it again and now it only works if you click on an empty clip and then go back to the continuing clip.
But i'm almost sure it did work this noon.

aarg, this is frustrating, I have a composition in which some clips with continue playback do not work as expected but when i create a new composition to reproduce the issue it does work fine.

Did you figure out a consistent way to reproduce this already?