Resolume Forum

is it possible to use a midi controller (like a doepfer) as a midi note.
example: use a slider to open tab3

Depends on the controler, i dont know if its possible to assign a note midi signal to the slider on your unit. If its possible you shuld do it in the editing mode of your controler or trough a editing softwere for your controler.

Its possible on a BCF2000 unit, but it also has buttons so im not using it.

i'm using a doepfer pocket dail and a pocket fader. can't really figure out how to configure it... i wish i could make the layer active when changing it (like layer speed).

You have a few buttons on the device, Maybe you can issue a note signal with them.

no can't use those, those buttons are for bank select and channel...