Resolume Forum

Hello,

Since updating to 4.5.0 I cannot access anything from the output sub menu.
If I use any older version, there is no problem.

Basically when I run the program everything works fine apart from anything in output menu.
As you can see in the photo:
Full Screen and Windowed are greyed out.
"Disabled" is selected but it cannot be unselected.
"Syphon" does nothing when clicked
"Advanced" does nothing when clicked
FPS, TEST CARD and DISPLAY function correctly.


I have my projector hooked up via VGA and i'm getting a signal.
Displays my extended desktop fine and I can mirror no problem.
I have an image in the display output monitor and can get a preview within Resolume.
It's just resolume isn't outputting...!
Am I missing a new setting within the new version...?

Any ideas?

P

p.s thanks to Visionz for the source footage!

Are you still running OSX 10.6 by any chance?

Avenue 4.5 and Arena 5.0 require OSX 10.7 or above: http://resolume.com/software/specs

Joris.
Thank you.
Thank you so much!
I am a fool.
I will actually take the time to read the documentation next time...

No problem, patchwork. This is totally our fault for not being clear enough.

Versioning and minimum requirements are a bit of a jumble right now, with 4.2.2, 4.5 and 5.0 all being active releases at the moment.