Blending The Correct Edge
Posted: Sat May 21, 2016 19:18
Apologies if this has been asked before. I didn't find it anywhere:
When I have two projectors overlapping side-to-side, with a very large amount of overlap (say 40% although I'm not in front of the setup right now and can't check), the edge that Resolume tries to blend becomes the bottoms, rather than the sides. I have a very big museum installation job that is coming up, for which this is a critical problem. I'm covering walls that are slightly too long for individual projectors, but close enough that they are overlapping quite a lot. The screen designs and rigging points are already set. I need to figure out some way to resolve this issue. Anyone have any advice?
When I have two projectors overlapping side-to-side, with a very large amount of overlap (say 40% although I'm not in front of the setup right now and can't check), the edge that Resolume tries to blend becomes the bottoms, rather than the sides. I have a very big museum installation job that is coming up, for which this is a critical problem. I'm covering walls that are slightly too long for individual projectors, but close enough that they are overlapping quite a lot. The screen designs and rigging points are already set. I need to figure out some way to resolve this issue. Anyone have any advice?