Resolume Forum

Hey,

What is the the usual way to do a soft edge and a mapping? Do I have to do them on the same slice? Thats difficult because I cant see my content and the test card at the same time. Or do I have to do the mapping on another slice/ screen? In this case I cant see my mapping changing (live) in the advanced output mode?

My setup: 2 Output Displays (Projectors) on the Graphic Card

The Softedge is working good but now I dont find a way to map my content on the surface... sorry its basic stuff I know

There is an extensive discussion concerning the advantages and drawbacks of several techniques for combining blending and mapping in this thread: viewtopic.php?f=5&t=13592&p=55824

thanks a lot!