Page 1 of 1
Fusion problem , no fusion in my output
Posted: Sat Aug 26, 2017 15:21
by FabS
Hi guys !
I have a little problem, when i'm doing a fusion with two layers, the fusion works well on resolume software but not on my output, why ?
I did a video to show you what's the problem :
thank you
Re: Fusion problem , no fusion in my output
Posted: Sat Aug 26, 2017 15:44
by Oaktown
What do you see in the advanced output when you preview the output transformation of that screen?
Re: Fusion problem , no fusion in my output
Posted: Sat Aug 26, 2017 15:51
by FabS
Re: Fusion problem , no fusion in my output
Posted: Sat Aug 26, 2017 15:58
by Oaktown
Can you describe your output setup?
Re: Fusion problem , no fusion in my output
Posted: Sat Aug 26, 2017 16:08
by FabS
Gelec PHANTOM P30
160x64 pixels
Re: Fusion problem , no fusion in my output
Posted: Sat Aug 26, 2017 16:11
by Oaktown
I'm not familiar with that particular panel and I can't find it online so can you send me a link to the spec sheet.
How are you connecting your computer to your panel?
Have you tested that same output with a regular HD display?
Re: Fusion problem , no fusion in my output
Posted: Sat Aug 26, 2017 16:21
by FabS
http://www.glec.de/download.php?article ... 201104.pdf
Macbook pro with resolume > Glec processor in DVI > fiber 100m > led screen
everything works well except fusion i don't understand why
Re: Fusion problem , no fusion in my output
Posted: Sat Aug 26, 2017 16:53
by Zoltán
I guess you have the slices in advanded outuput, slice input set to Layers, and slice 1 is probably layer 1 slice 2 from layer 2 and so on.
Check your input slices, on the right side you'll find a Input source dropdown, select Composition.
You don't need more slices than one if you are outputting from composition mix only.