Resolume Forum

HI,
after update there is something wrong with Group monitor. It does not respond to layers being bypassed in that group.
If i bypass all the layers I can still see the content in the group monitor but not when i look at video router with source set on that group.
Actually that group monitor should be blank too if all the layers inside are bypassed.

Also when i bypass only one layer, i cann see them afterwards both in video router output...
I have tried to make a example composition and screenshots

These are both major problems for me

I created a ticket. (#10093)

Do you have some estimated date of the next update? Im afraid i have to roll back to beta 3 until that time
since Im wery relied on proper group monitor output
Thats a pity because the reported problem with updating multiple thumbnails has beeen fixed now in new version and I would miss that too