Resolume Forum

I am trying to change the main program interface of Resolume to run on my primary display, but it is always staring up on the other display. I have tried many options on the Windows display settings, but it does not have any effect. I could not find any where in Resolume where I could change this setting.

My objective is to have the output on the second display adaptor and hook it up to a TV. Is there anyway I could do set the main intereface to run on the primary adaptor?

I am using an onboard Intel Xtreme contoller as the primary display, and an S3 VirgeDX PCI card as the second, on a P4 2.66GHz system.

i think its a primary graphics cars question, so go in the BIOS and make your onboard graphics card the primary one.
if it is, make sure the 2nd display is to the right of the primary(in your screen settings).

good luck!
SuperficiaL...

you can also control this in resolume, in the monitor settings you can chose which monitor has the interface and which has the video out.

yes very true, but i thought he meant as a default setting...

greetz,
SuperficiaL

Thanks for the replies. I will try whats suggested.