Resolume Forum

Hi, I'm new to this:
1 - Is edge blending purely software based in Resolume, so that it can be used with any pair of same projector type, or does it depend on edge blending properties in the projectors?

2 - If it is SW only, will it send to separate outputs for each projector (let's say I have two 1080- sources, will it then output 2x1080, one for each projector, or will it have to be made as one wide format video..somehow..? I wonder if I can use this together with Userful...

Thanks in advance.

/ivar

Hi Millimedia,

1. In Resolume softedging it's truly software based. There is no connection to the projector. So you can do it with any projector. ANY....even if they are different...but the result would not be that nice.


Here I tested edge blending with 3 70,00€ china led projectors....feeded from one 1080 clip in Resolume...you loose pixels...because the aspect ratio is not 16:9.....it's much wider....so the image is cut at the top and the bottom.... 2. Yes...short... every projector needs his own output from Resolume for softedging.


best wishes
cosmowe

Great, thanks!
/i