OSC Parameter range
Posted: Wed Jun 20, 2018 07:55
Hi, quick question here: Is there a way to set ranges for a parameter when using OSC? I'm trying to build some templates in TouchDesigner to address automation situations I often come accross. What I'm trying to accomplish is to have all the logic in TD using normalized values (0.0-1.0), and then map IN RESOLUME the appropiate range for a given parameter. This way I could have a normalized overview of all animations going on in TD while still addressing the desired values in Resolume.
I know this is the standard behavior when using, for example, the timeline automation. And it even uses the envelope correctly with the reduced range. I also know that the envelope is applied even to external triggers, such as OSC data. I think adding the possibility (if it isn't there already) of choosing an in and out points for external control would greatly increase versatility when creating control interfaces.
I know this is the standard behavior when using, for example, the timeline automation. And it even uses the envelope correctly with the reduced range. I also know that the envelope is applied even to external triggers, such as OSC data. I think adding the possibility (if it isn't there already) of choosing an in and out points for external control would greatly increase versatility when creating control interfaces.