Resolume Forum

Hello, so I recently switched to using PC and am now running into an issue with my midi controllers. I use an Akai APC40 mk2 to control resolume, and then a livid BASE to control mad mapper. However, it was seamless and not an issue to run each midi controller to each software on Mac, but now on PC, it seem that either Madmapper or Resolume will take both controllers and the other software will not be able to access it, depending on order of software launched and hardware plugged in. How do I "Pipe" and decide which controllers go to which software?

On OSX, more than one application can use the same MIDI device at the same time. On Windows, only a single application can 'own' a MIDI device.

In the MIDI tab of Resolume's preferences, you can toggle the devices you want to enable for Resolume.
https://resolume.com/support/en/prefere ... references

I'm assuming Madmapper has a similar preference pane.