Resolume Forum

Hi Ive just installed the new version, hoping of finding the feedback to my midi controller. But it Resolume sends nothing back....so when i move for example opacity, value of the rotary button on my controller stays unupdated....does anybody knows why? Thanks for feedback

.....Im talking about midi out signal to my behringer

where in the 2.3 release notes does it say that resolume outputs midi??? oh.. it doesnt

your just gonna have to wait for a bit, bart and edwin are quite busy

Hmmm...i read something as a midi feedback and thought its midi out signal. I hope this function will be available soon

when you're only using the rotary buttons, you should be fine configuring them as endless controllers. There's no feedback indicator, but you don't get value jumps when using both midi and mouse to adjust values...
For faders (motorised) it would be great, but not really more then a fancy gimmick...

just don't use the mouse to control fader values

Driver and Firmwareupdate for BCR or BCF! I use the V1.10 Firmware an have no problems with Feedback...