Page 1 of 1
Pixelmapping Astera AX-1
Posted: Mon Feb 24, 2020 15:59
by FL_Light_Berlin
Hey Guys,
Has anybody a Resolume Fixture for an Astera AX-1 Pixeltube in the RGB-S (S=Dummy) Mode Witz 16 Pixels (64 Channels)
Trank you and best Regards
Re: Pixelmapping Astera AX-1
Posted: Mon Feb 24, 2020 21:56
by He2neg
There is a fixture creater inside Arena, is ther something special about the "dummy" mode i´m not aware or do you have another problem?
Re: Pixelmapping Astera AX-1
Posted: Tue Feb 25, 2020 00:25
by FL_Light_Berlin
I know the fixture builder wich is inside Resolume. But I have more than 1000 pixels and the AX-1 are in RGB-S (S=Shutter) mode. Every Stick has 16 of these Parameters. If I build this Fixture with the RGBW-Preset, which is implemented in Resolume, I have strobing pixels if I map a black and white Clip. (Same Problem with the RGBA-Preset and red/orange Clips)
I know you can turn off the Shutter, but it will be a lot of work, because the Sticks are in trusscircles in the roof.
Re: Pixelmapping Astera AX-1
Posted: Tue Feb 25, 2020 14:01
by He2neg
As work arouind you can build a fixture for 1 pixel and copy this till you have one astera ready and then copy this as a whole...
inside the fixture generator you see a small + at the bottom( of the collum you can set the rgb / rgbw etc...) this add a dmx channel so you can have a rgb + Parameter Fixture.
This parameter can be set manually and hold this value.
maybe this work for you.