Resolume Forum

Hello all.

I am new to the resolume world. However, I am using it for a new upcoming project, and need to use well over 16 universes. However, I am having an issue here. The EPIX Drives do not allow for me to edit their subnets. They count universes 0-254. So, on resolume I need to send Subnet 1:Universe 0-7 to Universes 16-23 on the EPIX drives, but the drives are not recognizing it. Is there a way to fix this? Am I missing something? Or can Resolume only communicate with the EPIX Drives with 16 universes?

Resolume can send 256 universes to any single destination, and counts universes from Subnet 0: Universe 0. this is the first one.

Subnet 1 : Universe 0 is the 17th universe, Subnet 2: universe 0 is the 33rd universe, so once you mapped out 16 universes in subnet 0, you can increase the subnet, and start mapping 17-32 (S1:U 0-15)

Zoltán wrote: Wed Apr 22, 2020 09:23 Resolume can send 256 universes to any single destination, and counts universes from Subnet 0: Universe 0. this is the first one.

Subnet 1 : Universe 0 is the 17th universe, Subnet 2: universe 0 is the 33rd universe, so once you mapped out 16 universes in subnet 0, you can increase the subnet, and start mapping 17-32 (S1:U 0-15)

I am aware of this on the Resolume side, but it seems that the EPIX Drives are not recognizing any artnet universe above the first 16. I know this is not on the EPIX side, because it works fine with other softwares that count artnet universes like the drive does (0-254). Do you know of how I can make them communicate with each other? I prefer resolume to all other softwares, and so I really need them to work together.

So, what output setting have you tried to send universe 17 from Resolume?

Have you tried to contact Chauvet about how to receive from Art-net devices that number universes differently?