Resolume Forum

I am getting some strange behavior trying to assign MIDI controllers from a UC33e to Resolume.

Basically, I can assign any controller to any of the parameters - except for MIDI CC #1. Resolume recognizes it, and assigns it, but moving the controller does nothing.

I have checked this in MIDIOX, and the controller is working normally. This used to work fine in Resolume 2.2. This happens regardless of whether I route through MIDIOX or connect the UC33 directly to Resolume.

I remapped CC#1 to CC#34 using MIDIOX and now it works fine in Resolume. I suspect a bug in Resolume, check your boundary conditions...

[Edited on 18-11-2005 by gpvillamil]

[Edited on 18-11-2005 by gpvillamil]

I reinstalled Resolume and it worked fine - for a bit. Then it started ignoring MIDI CC #1 again. You can assign it, but it does nothing. MIDIOX shows it working normally.

Happened in a gig last w/e, fortunately the MIDIOX remap trick worked.

I get this too. have reported it, I wonder when were due an update?