Resolume Forum

Hi folks,
I have just noticed a rather annoying thing: I have put some effects onto my composition and want to control their opacity via the dashboard, using a MIDI device. I have noticed that one of the dials on the dashboard does not reset to zero. This is probably because I assigned an effect to it, and constrained the opacity parameters for that effect. the thing is that I then didn't like what I saw, and so deleted the effect. The annoying thing is that now I cannot assign anything else to that specific dial on the dashboard, as it seems to have 'remembered' the parameters. Is this a bug, or is there a way to reset this?

Did you remove all assignments from the dial?
It gets the first param's default, and keeps it until all assignments are removed. Then wen you assign a new param to it, it should get a new default.

Yes I did, but it still lingered on, even when I quit Resolume, which I thought was a bit odd.
That said, I have just turned on again and it all works fine, so just a little glitch somewhere in the matrix...
All good!