Resolume Forum

Hello community,

I am triggering cues by launching columns.
My question is: Is it possible to set separate transition times for different columns or clips.

The only way i found is to set different opacity envelopes for clips.
It works, but is a bit inconvenient if it has to go fast and you have many clips

Perhaps there is a better solution.

All the best,
H.

Try this app, it can set the transition time for your layers while also managing the column launch for you:
http://palffyzoltan.hu/?url=controller

Thanks a lot Zoltán !
This App sounds promissing.
Will definitly check it out on my next project.

All the best,
H