Resolume Forum

Hi All,
I'm making a DMX profile for resolume and one of the things I want to do is be able to change pages from a DMX channel. I.e. channel 5.
DMX Chart:
0-10 - Safe
11-20 - Page 1
21-30 - Page 2
31-40 - Page 3
...

I set all the pages to the same DMX channel however this does not work. I also tried adjusting the range however this also doesn't work. Is there any way to change pages using the same DMX channel?

This should get you:

Legend! That works!

Edit: Found it. Edit DMX shortcuts then above those buttons is a ">" button

Do you know if there is a similar way to do that for clips in columns per layer? - I tried adding a DMX shortcut to the same button for the clips however it only triggers next. Is there a way to make it a similar thing where,
DMX Chart:
0-0 Clip One
1-1 Clip Two
2-2 Clip Three
...
etc?

Each layer also has a > that does the same thing.