LEDs constantly flicker (Advatek Drivers)
Posted: Fri Jan 06, 2023 21:11
Hello there,
I have a fairly large amount of LEDs that I'm trying to run through Resolume that are currently being ran by Madrix without issues.
I was able to connect to the LEDs, but I have an issue of them constantly flickering. They are receiving the data and will change to whatever I have running in the channel, but even using a static color they flicker non-stop. If I switch back over to Madrix they work just fine.
I also noticed they don't dim using the sliders, they are either on or off, toggling around 30% on the master.
I am very novice to all of this, so I'm guessing I have some setting wrong somewhere. I've searched here and google and couldn't find any mention of this issue elsewhere.
Any ideas? Thanks!
I have a fairly large amount of LEDs that I'm trying to run through Resolume that are currently being ran by Madrix without issues.
I was able to connect to the LEDs, but I have an issue of them constantly flickering. They are receiving the data and will change to whatever I have running in the channel, but even using a static color they flicker non-stop. If I switch back over to Madrix they work just fine.
I also noticed they don't dim using the sliders, they are either on or off, toggling around 30% on the master.
I am very novice to all of this, so I'm guessing I have some setting wrong somewhere. I've searched here and google and couldn't find any mention of this issue elsewhere.
Any ideas? Thanks!