Resolume Forum

Dear Resolumees,
I found DMX in Resolume to be a little buggy. I use DMX via Art-net via a Kissbox. In other software it works as expected.
# I have some dirty signal in my DMX universe, i don't know where that is coming from, but when i enter the "Edit DMX" Tab, the automaticaly active learning stage is messing up my allready made triggers.
-> it would be nice when the "learning function" could be toggled like in other software. On resolume the only workaround i found is to delete the universe in the settings before i enter "edit DMX"
# The DMX Monitor seems to be buggy. I have a signal which shows in the monitor, than i disconnect the cable, but the signal is still showing i have to reopen the monitor
# I have a signal of lets say channel 183 value 255 and trigger a column with that, which works. But after a few seconds the detected signal (also in the monitor) jumps back to 0, and than a few seconds later is triggered again. This happens in the composition as well as Monitor

I am on Windows 10 and Resolume 7.20.1 rev35767
cheers,
-johnny-

Any other apps running on the machine which might send DMX?

Do you still see input after disabling Resolume outputs, and disconnecting cables?

yeah, sometimes the input is still visible in the monitor, even though the cable is pulled. Closing and opening the resolume monitor is fixing the problem.

Do you mean you see the monitor keeping the last values received?
That's how it should be, so you can see what came in.

I had an issue where Universe 0 was not working reliably, we never found it but we suspect that something on the network was broadcasting on that universe. Try using Universe 1 or another to see if things stabilize?