Resolume Forum

Hello,

I have a big problem with a Matrox QID PCI-E LP video card (4 outputs)
If i start resolume without the latest driver from Matrox it detects 4 displays and it works well but this is not a solution for me because i need to rotate 90 degrees display no. 4 and without the matrox driver i can`t do that. The problem is that after i install the driver from matrox resolume sees only 1 display installed.......
Can you please help?

Hi , I have one PC system with Matrox QID LP PCIe for use with 4 proyectors and in the same PC i have the Matrox P690 Plus LP PCIe X16 to use for the Resolume interface in one TFT 20". I have ASUS P5E WS Pro with double PCIe 16X. Using the unified driver 2.05 from matrox I can set the streched mode in 4 x 1 , to prepare big surface for the output in windows XP and even in the screen setup in the Resolume I can see and set the output in fullscreen mode to the QID that, but the output can only be 320 x 240 mode , and it doesn´t work with the right resolution for each of the four projectors in 1024x 768 or 800 x 600 for enjoy one big display in 4096 x 768 or 3200 x 600. Even I need to delete the screen setup file before to run again because saving settings the system is hung up all the times. I someone knows one solution to redirect the output in the right resolution, please , contact . THanks ciovni@terra.es