Resolume Forum

This has happened to me twice now.

R2.41 has been running a set for some time, with a range of different clips being used. Everything seems fine.

And then I go to load a new clip, and the software is unresponsive, and then a few seconds later, bombs out and exits with no error message.

I am going to keep an eye on this with the logging mode enabled, But I wondered if anyone else has experienced this, and could offer some insights.

I am switching between applications e.g. Ableton Live and cannot avoid doing that and wondered if this upsets Resolume?

Thanks
Richard

Are you also sending midi from Live to Resolume? Sometimes sending too much midi signals can cause Resolume to overflow and crash.

There wasn't any MIDI data passing between Live and Resolume at the time of the crash ... Live may have been open though.