in/out point sliders fft
Posted: Sun Apr 05, 2009 20:20
I noticed a "visual" error in the GUI with the in/out point sliders from the fft band-range selection sliders.
When you narrow down the fft in/out point sliders to a specific range in the grafical equalizer
then minimize the equalizer and open it again
the "in" point is back to the left side of the equalizer... BUT... the setting is still there, so when you narrowed down a part in the high frequencies it's still responding only to that part, which is a good thing 
Also... when you click the "in" point the first time it jumps back to where you set it before.
Is this just on my machines?
When you narrow down the fft in/out point sliders to a specific range in the grafical equalizer
- Clipboard01.jpg (22.58 KiB) Viewed 3154 times
- Clipboard02.jpg (19.86 KiB) Viewed 3153 times
Also... when you click the "in" point the first time it jumps back to where you set it before.
Is this just on my machines?