Resolume Forum

Just found a bug relating to the feedback-source.

I had a comp at 640x480 and then later on changed it to 1280x1024. I wasn't seriously compositing, just experimenting, that's why I didn't pay attention to the comps resolution in the first place. Now what happens is that every feedback-source that I applied before changing comp's resolution, therefor is 640x480, get's set back to it's original size whenever I switch decks or reopen the comp.
This is very frustrating as one would have to replace all the 640x480 feedback-sources with 1280x1024-sources as they don't get changed (as long as the comp's size sticks to that res ) and redefine all the parameters. And this takes me to a wish: Pleeeeeease make every attribute copy-paste-ready not just the effects.
And yet another idea/question: would it be possible to have a solo-feature for feedback-sources so only the feedback gets rendered on screen? I can allready see it rendered solo in the preview so that shouldn't be too difficult I hope.

Best, J

Thanks for the find Tschoepler, I can recreate 100% on my end. I'll make a ticket out of it and also a feature request for the feedback only render mode.

Joris

thx

Right click on the clip handle and choose settings. You will be able to alter the render resolution of the source.
When rendering the feedback can't you just set the layer to solo, wouldn't this be effect your after?

hey hey hey
right click did the trick. allthough it is still a bit of a pain. but it works, thx.

soloing the feedback clip won't work. just oputputs a black screen.