Resolume Forum

hello guys when I do the mask in Resolume seems to be smaller than when I was making it in photoshop. The lowest resolution available on my projector is 800x600 so I set Resolume to output in 800x600 then I also made my mask in photoshop on 800x600... but when I use the mask in Resolume it appears to be 10-20% smaller in the output. Any ideas what could be causing this?

Also, is there a way to lock the canvas in photoshop? It keeps moving when I'm drawing near the edge. please help thanks

i have tried thousands of time its not on spot please help in detail .

Ok. You set Avenue output resolution to 800x600, but what about your composite settings? 640x480? : )
Or... have you checked if your (composite properties tab) / scale value is lower than 100%.

Paulo

yes the composite properties aret thesame size of my output settings and also the mask is of the same size still not on spot

About your photoshop issue :
In this blog post, there seems to be an answer to your question, en also some interesting other ideas.

http://blog.resolume.com/blog/post.php?t=6151

also note that the mask is allways brought down to the size of the video clip it is masking
this can be a problem sometimes........
anyway to move or resize the clip witout doing the same to the mask ???