Resolume Forum

on the mac I'm not getting correct audio input when i set a parameter to animate with FFT to clip mode, this is when i have a silent video clip and a wav attached to it. it sometimes reads from another layer? have you noticed this?

Hey Leo

I can't seem to recreate this. Maybe you can send the project and the clips to mail-at-resolume-dot-com?

Joris

any clips like the demo clips for instance. i worked out it happens when i have clip target to active layer and trigger from say the middle row to a layer that isn't the middle one.

and when i trigger two clips from the same row that are set to clip to different layers they both take the audio from the same clip on that row they are on

so in essence 'clip' mode is layer mode

Thanks for the clear steps. I'm able to recreate this 100%, and made a ticket for it.

Thanks for the find!