Resolume Forum

This is a subtle one...

I'm using the Resolume Max for Live patches to trigger clips in Resolume.

Straight clip triggering works perfectly using the clip launcher.

However, triggering (via OSC) effect clips in a layer that only contains effect clips does not work. (Triggering the clips manually works).

Moving the effect clips to a row that contains other clips DOES work.

Not sure what is going on here. Might need to look at the clip trigger mode or clip target.

Hmmm. I can't recreate this. Effect clips trigger fine via OSC, either with absolute or contextual addresses, and in their own layer or together with other clips. If you can recreate it again, could you tell me the steps on how to go about it?