Resolume Forum

so i was playing around with a Swann ADW-200 with two wireless cameras. I can get resolume to see the cameras but they freeze. i tried just doing just one because they would freeze every time i would switch them, however i can only let it run for about 10-15 seconds before it freezes. any ideas???

How is this camera connected to your system, and can you get it to work for more than 10 seconds in other applications?

turns out these are just crap. waste of 20 bucks. they work great when i have them connected composite but when I connect them via USB i can only hold a signal is ANY application for about 10-15 seconds. I would need to run them composite through a capture card. there is no customer support, there are no drivers, no firmware, no hope....