Resolume Forum

Yes, I have used it succesfully on a mac and was also able to get the midi clock in Windows using rtpMIDI!

Works very good but in my opinion €140,- is to expensive.

Nevermind! I found what was bothering me! For some reason the XML with de presets for MIDI was the problem. Now everything works as it should be and I'm impressed!

When trying to MIDI map Resolume 3.01 crashes...
(Why isn't it possible for me to map layer controls in 3.00?)

**********************************************************
Resolume Avenue 3.0.1 rev1500
Log started: 5 Apr 2009 1:49:59 pm

logging has started
system language is: nl
registration invalid ...

Patronaat Haarlem, The Netherlands

When I'm changing between decks, I have 50 clips per deck, the framerate drops from 60 FPS when using 2 layers to about 4 FPS for 10 seconds. This is very annoying and it keeps me from browsing through my decks searching for that one clip. Someone with the same problems or a solution?

For specs of ...

After reading your succes with the BCD I tried to set up mine with Relative 63-65. Again it didn't work the way it should work... So I re-installed the drivers and Resolume and... it works now! :D :D :D :D So thank you so much for your help! :D

Still have some small problems though :oops: When I ...

The new beta doesn't offer any solutions. However if I assign a jogwheels to a playhead now, with mode Relative (0-127) and I give it a spin the playheadcursor goes backwards, doesn't matter which direction I spin the wheel. :?

The BCD3000 works great, the only problem is the playhead.
I'd also ...

Tried to pause and then spin the wheel: it still jumps to the center of the transport line...
As for the step value: it stays fixed at 31.797, so I can't change that.

I also tried to hook up my BCD3000 with Resolume 2.41 (on the playhead). Fixed it also jumps to the center, when set to endless I ...

Additional information:

When I put the jogwheel over Transport in direct midi mapping in mode Absolute and I spin the jogwheel the clip jumps to the center of the transport line, when in mode Relative (0 - 127) and I spin the jogwheel the clip freezes until I stop spinning. In mode Relative (63 ...

If I monitor the signals of the jogwheels in MIDIOX when I spin them forwards you will see no change in the DATA2 row, it stays 41. When you spin the jogweels forwards very fast DATA2 will vary between 41 and 49. When you spin the jogwheels backwards at an even speed DATA2 will be 3F, when you spin ...