Hello there,
Having had quite a bit of success with both TouchOSC and Logmein...
(for seperate uses)...
I was hoping to use an AdHoc connection via other VNC clients om the iPhone to help in tweaking Keystoneing/Masking while (not) standing next to the laptop.
- For some reason Resolume's interface doesn't respond to the normal left and right clicks supported in most iPhone VNC apps.
I was hoping to drag around sliders arbitarily you see.
- Has anyone had any success with this?
iPhone VNC problems using Resolume
Re: iPhone VNC problems using Resolume
Also as a note to the above:
I've tried using the iPhone's 'Logmein Ignition' over the internet - and the drawing/refresh/driver used by Logmein works fine with Resolume - and allows me to drag parameter sliders etc.
- But of course the likelyhood of having a usable internet connection at each site is a bit of a wing and a prayer!
- Hence me wanting to get a VNC app running which will allow for IP - specific addresses into the Host field.
(Which I don't think Logmein Ignition can do...)
I've tried using the iPhone's 'Logmein Ignition' over the internet - and the drawing/refresh/driver used by Logmein works fine with Resolume - and allows me to drag parameter sliders etc.
- But of course the likelyhood of having a usable internet connection at each site is a bit of a wing and a prayer!
- Hence me wanting to get a VNC app running which will allow for IP - specific addresses into the Host field.
(Which I don't think Logmein Ignition can do...)