Clip reconnect - wrong playrange --> slower playback

[Rene]

Hello,

I've read somewhere else in the forum about clip reconnect issues, not sure if this issue is related to the other.

When I reconnect a/v-clips* the duration (in and out points at the timeline) are set to 5 seconds instead of the whole length. (e.g. in-point = 0.00, out-point = 5.00).

Screen Shot 2012-09-15 at 10.03.44 AM.png (22.95 KiB) Viewed 6160 times

the same happens to effectclips with audio

Screen Shot 2012-09-15 at 10.02.06 AM.png (28.53 KiB) Viewed 6160 times

Note: It seems that this only happens if the clips are set to play the full range. I have one clip which plays just a section, and it is reconnected properly.



* clips are a/v and are composed of one video and one audio file, set to 'BPM Sync' transport and '32 Beats' playback.; Audios are according to QuickTime 'Linear PCM, 16 bit big-endian signed integer, 2 channels, 44100 Hz' in aiff containers; 2 videos: one is h264 25fps 1920x1080 and the other DV-PAL 25fps 720x576) both in mov container. (I can try with DXV, if you think that the codec is related to the issue. Edit: tried with DXV, same thing)

[vj granda]

Same here but my clips are DXV and without audio and BPM Sync...
I'm on rMBP Mountain Lion.

[edwin]

Hmmm, yes we just found out this ourselves as well. We are looking at it, will be a fix for this in 4.1.2.

[gregsully]

THIS IS A MAJOR ISSUE!!!

I'm having the same problem AND ITS A REAL PROBLEM.. Its happening out of nowhere on certain clips and I have no guarantee that when I fire off a clip that it wont be on of the ones that's gotten speed corrupted..

If this goes bad in the middle of a big show it will be the last time I will be using Resolume in a corporate show.. Not because of me.. but because all confidence will be lost in the platform..

Please send out a fix ASAP!

[Babcom]

OH GREAT! Its not just me then with this issue... I hope for a solution soon. Had quite some trouble with this bug.

All the best. From Sweden