LEDs constantly flicker (Advatek Drivers)

[dxcade]

Hello there,

I have a fairly large amount of LEDs that I'm trying to run through Resolume that are currently being ran by Madrix without issues.

I was able to connect to the LEDs, but I have an issue of them constantly flickering. They are receiving the data and will change to whatever I have running in the channel, but even using a static color they flicker non-stop. If I switch back over to Madrix they work just fine.

I also noticed they don't dim using the sliders, they are either on or off, toggling around 30% on the master.

I am very novice to all of this, so I'm guessing I have some setting wrong somewhere. I've searched here and google and couldn't find any mention of this issue elsewhere.

Any ideas? Thanks!

[Zoltán]

Sounds like the leds get conflicting data from two sources, or they can't handle the 40fps DMX data.
Lowering the send rate in Resolume could help in that case.