Resolume lumiverses -> Capture Nexum led stripes

[ketsid18]

Hey,

so i've ran into problem where i need to get signal from RESOLUME LUMIVERSE into CAPTURE NEXUM
but since capture is not an artnet device.. its kinda problematic.. and i actually never done controlling LED stripes (ADJ ultrabar 12) from resolume before... so what would be my steps to control them should i attach console in middle to have control over fixtures and take DMX in to console and then send it DMX out to capture? or what would be the ways of doing it?

[AdevProjects]

Capture is Artnet / Network DMX Only.

This will work directly from Resolume to Capture on the same computer. You will also be able to connect a lighting console into Capture at the same time. See capture page:
http://www.capturesweden.com/Support/Connectivity

Resolume DMX Output Page:
https://resolume.com/support/en/dmx