Resolume Forum

Hey there,
may found a little hickup. Copying a wire patch inside the clipdeck does not carry all information with it. Maybe because they are negative?

EDIT: It seems not because the value is negative...the reason seams to be because I use two Float In nodes with the exact same name "Y"... When I rename one to for example "Y_" the value is copied correct.

Wire & Resolume 7.11.3


--begin-wire-patch--
416.3oc6TFraiBCDF9cwmAzXi8XH2R2c6yvVUsGb.2h0Rrq.S6VUk28NFRT1zKzi4P3.fG9v+19+WyGrlf2aahtfejs4w+jw7gVK85GLtNc2DiCtcSwkZO0GdK8L99KV1lkgYrWM8Sogitm8ld1gLVmYLeu4e+G5tPn+LZbXxdBy4WCy4GiFeyxR3HneZ+N6vYTNwcohekP..jftPuuBkOSQX6BS91YA6rtm6hrMUhL1at1XGIVIjwHsxkhpBDzUxZtfC0kZUF6cpNBxhJsRJzBINWmlxldy37L5ZIk0ZrVKPU9OEkpb4Vba9cHxyAw169kR8Cs396SqK6vHYNrMv7LDZ9K8uu5ZsA5iMg9vPxGnKz.vbo4Cq3hP9WlhW5Wl34Mqbdm14Zasj.OdDOkAL6S3+NYk7pawfUiAkPgD0nhWhZd0oTfhqKfZJ.Hk0hT4qwPPtZkTvCImT.2RAq2LPVfJTbz8E.uPxoFCURttFuRs+uUO.A+l6ut6iEJNBJwoV9Kw.Nur.KqJAEhRfRGWiof0aAPeevNFlFVN6Ob3SPV4E1E
--end-wire-patch--


Best wishes
cosmowe

I think it's because the parameters are named the same.
With those Resolume can get confused a bit.

Rename the params so they have unique names