Resolume Forum

The midi cues I have used to clear content is not working properly. It seems to not use the cue to clear a layer that has content on it, which is the whole point. It does however show the activation on layers with no content. This is the same system I always use, it has always worked before, and has not been unplugged. Looking for help or ideas. Did something change I need to fix, or is it a software malfunction?
Ex. I have a column selected with multiply layers in use, I have midi cues triggering out of the song to clear everything but the one layer I need, and it selects a video, and the video plays seamlessly. Now, the video is selected, yet the motion graphics are still coming through an not clearing according to the cue, and it looks like bad. I even reset the midi cues, tripled check them, and made new cues all together. Nothing is working.

If layer transition time is enabled, then it would take a few seconds for layers to clear.
https://resolume.com/support/en/layers#layer-transition

Layer content can also be locked.

Zoltán wrote: Sat Oct 28, 2023 13:55 If layer transition time is enabled, then it would take a few seconds for layers to clear.
https://resolume.com/support/en/layers#layer-transition

Layer content can also be locked.

Nope, none of this. Doubled checked. It's weird, because i can physically watch the blue selection go in and out when there is no content on the layer, signifying the cue is triggered, but with content it does nothing.

Could you make a screen recording?
Would be interesting to see what you see.