Resolume Forum

So I have a new MSI Titan and upon loading resolume, if I move the interface on the main monitor it blinks the whole screen. It doesn't seem to blink the output but main monitor totally blinks (which may effect ndi captures from main screen which I used from time to time). Has any one else run into this? Is there some Nvidia Global or Program setting I should change? Already turned of Peak and am going through other settings but seeing if anyone else has had this issue or has a fix.
Thanks

So... one solution I found.. If i enable NDI's Screen Capture HX and load it on to resolume to try and capture the problem and record it, it pretty much makes it go away. Very odd work around and not sure if NDI is the cause or its the Intel GFX card and the Nvidia card..

Upon further investigation, its the 144hz on the monitor. Looks like Resolume doesn't like that fps. Drop down to 60, problem solved.

If you enable show display info in Resolume output menu, and send a windowed output to your main display, what does it says as GFX card and renderer?

Attached

So through the MSI Center I changed it to Discrete Graphics Mode which seems to work good now. Stress testing with 3 outputs and 6 layers to see if the problem is solved.