Page 1 of 1
Is it possible to command the switcher via RS-232C from the resolume?
Posted: Sat Apr 13, 2024 07:45
by maruo
Hello,
I want to send commands from resolume to the switcher via RS-232C.
rs-232c or the Ethernet method is also acceptable. We would appreciate it if you could tell us how to set it up.
Re: Is it possible to command the switcher via RS-232C from the resolume?
Posted: Sat Apr 13, 2024 14:52
by Arvol
Directly, No.
However you can send out OSC or DMX from Arena and then use a free translator app like Chataigne to convert to other protocols.
Re: Is it possible to command the switcher via RS-232C from the resolume?
Posted: Mon Apr 15, 2024 10:05
by Zoltán
The switcher might support Midi, Resolume can send that.
Re: Is it possible to command the switcher via RS-232C from the resolume?
Posted: Wed Apr 17, 2024 14:36
by maruo
Mr. Arvol, Mr.Zoltán
Thank you for your response.
I will try to connect with OSC or DMX to check.
We will also check if the switcher supports Midi.
We will contact you again with the results of the confirmation.
Re: Is it possible to command the switcher via RS-232C from the resolume?
Posted: Sat Apr 20, 2024 02:49
by sipsipsips
Hello maruo,
From your image, I infer that the switcher is made by Imagenics (I am Japanese, so I fully understand the reliability of that Japanese manufacturer). Unfortunately, however, they do not adopt external control via MIDI/OSC/DMX protocols in any of their models.
Best Regards,
Tommy