Evaluating Resolume 3 vs Modul8, HELP!
Posted: Tue Aug 30, 2011 01:24
So, I'm trying to decide between Resolume 3 and Module8. I MUCH prefer Resolume's approach; HOWEVER, I am having some serious technical issues.
My laptop:
Macbook Pro (mid-2009)
2.53 Ghz core 2 duo
Snow Leopard 10.6.8 (fresh install, no other apps installed except Resolume and Modul8)
8gb RAM
7400 rpm internal drive (for software and clips)
Geforce 9400M (256mb shared RAM)
The test:
(all settings default, Resolume 3.3.2 demo, Modul8 2.6.3 demo)
640x480
Running 5 layers: three of the provided Resolume demo clips (UrbanTextures) and two additional DXV encoded clips (approx. 4 seconds long each).
Within 30 seconds of starting play, Resolume will beach ball. Any audio will continue to play, the beat counter will continue to run, but the output is frozen. This stays stuck for approximately 30 to 60 seconds. It usually happens again in another minute or so.
In Modul8, running the exact same clips (and default settings in the demo), it runs flawlessly. I can even add 5 more layers, load each with effects, and get no hiccups whatsoever.
I really want to choose Resolume, but cannot figure out why it is performing so differently.
(attached log files and glview report) ...odd that the Resolume log shows only 2gb of RAM detected???
My laptop:
Macbook Pro (mid-2009)
2.53 Ghz core 2 duo
Snow Leopard 10.6.8 (fresh install, no other apps installed except Resolume and Modul8)
8gb RAM
7400 rpm internal drive (for software and clips)
Geforce 9400M (256mb shared RAM)
The test:
(all settings default, Resolume 3.3.2 demo, Modul8 2.6.3 demo)
640x480
Running 5 layers: three of the provided Resolume demo clips (UrbanTextures) and two additional DXV encoded clips (approx. 4 seconds long each).
Within 30 seconds of starting play, Resolume will beach ball. Any audio will continue to play, the beat counter will continue to run, but the output is frozen. This stays stuck for approximately 30 to 60 seconds. It usually happens again in another minute or so.
In Modul8, running the exact same clips (and default settings in the demo), it runs flawlessly. I can even add 5 more layers, load each with effects, and get no hiccups whatsoever.
I really want to choose Resolume, but cannot figure out why it is performing so differently.
(attached log files and glview report) ...odd that the Resolume log shows only 2gb of RAM detected???