Resolume Forum

I think the image you are referring to was showing source laptop through Barco S3 on the Left side of image, same source going through Arena on the right side of image

Output from Resolume is out of NVIDA 3090 HDMI to HDMI of LED Processor if thats what you were asking??

Same signal, cable path and fine through VMIX, for some reason going through Resolume with no scaling introduces softness.

It is bizarre!!

SLICE SETTINGS

Additional Images as requested with some better images of LED Output

Hi, attached are a list of screen shots as requested.

My Initial reasons for doing the A/B Comparison were for latency testing to see if Resolume would perform as well as S3 for live camera to screen purposes and it seems to be equal to S3 on that front, but then this softness issue was brought to light.

I know once this is on a big wall the softness ...

I only use Resolume now and then when I need to slice for LED screens, my usual route is Barco S3 with 1 big wall, but I have noticed in the past that when i am using Resolume the screen has felt a little soft compared to what I am used to but never had the A/B setup to check it and just excepted it ...

Hi Zoltan, it is outputting through Advanced Output currently but I have checked if any different between Fullscreen output and Advanced Output but no difference. I have tried the test card and yes it does look soft also

Sorry it is a Decklink Quad 2 which does capture up to 1080p 60

Thanks for the info, I have also just dropped the same grid png file on a cell and this is also "soft" like the captured input, as I say I have used the decklink capture into VMIX and output fullscreen and this is sharp?!? The composition in Resolume is just a basic 1920x1080 straight through, no ...