Resolume Forum

Hmm in fact by coincidence i discovered that if an output was previously assigned to a (discovered) node and now a new node is available that uses the same IP address but has a different 'short name' the universe then defaults to 2 upon selecting that node. At least that is what i think happened ...

Well, when you select a discovered node, the Universe number is taken from what that node sent to Resolume.
That's why I'm asking if the universe 1 is what's set up in your node.
First of all, this is happening without any regards to the Node i am using. But what field off the ArtPoll Reply would ...

That seems to be completely irrelevant, normally speaking i set it to '0', but when i found out about the changing of the Universe, i started defaulting it to '1' to prevent issues.
Just did a small test to confirm that behavior, and regardless of what is being sent in the ArtPoll Reply, the ...

So as in the the Topic. When selecting a discovered node for a Lumiverse, the output universe changes to '1'
I did some testing and as far as i have found, this only happens when a discovered node is selected, not when an IP address is manually entered. (or when switching to 'No Output' or ...

Ok so sorry my bad, i had the subnet mask on the ethernet controller set incorrectly (255.0.0.0 instead of the proper 255.255.255.0) Now everything does arrive and show up. I guess it's the result of lack of experience with static IP address setups.
Could you provide me with a link on how to setup ...

Do you have a router/switch in the wired setup?
No i don't, but i don't have to.
That would be needed to route the packet properly to specific IPs
Well ehm, i am not really sure what to say to that, other than that i think that is just not true. There is no forwarding required. Forarding comes ...

Have you selected the Wired interface in the DMX preferences?

Yes i have, and all Artnet packages arrive just fine with the exception of the ArtNet Poll.
I am using the exact same code for receiving UDP packages on both WiFi & Ethernet, (other than specifying on which i am receiving) so i can ...

Hi,

As in the topic. I am developing Artnet nodes, and although i don't use Resolume much myself, i use it mainly for testing. Now i also work together with a deco artist that does use Resolume as his main program.
Anyway, we both find that Artnet discovery is 'sketchy' by Resolume, to say the ...