Resolume Forum

Buffer increased, all looking good so far...

Thankyou,

Mark Jolly

Hello (again),

I've been successfully running compositions on Resolume 4.0.1 with 8 layers, each running the same sequence of 10-30 second duration source clips, driven by the default forward-stepping Autopilot on each layer. The composition beat snap is set to off, every single clip is beat snap ...

I sense a glimmer of hope on my horizon!

Did you increase or decrease the buffer? What value works for you?

Thanks!

Mark

Audio settings are:

Audio Output Device: Primary Sound Driver (this is the standard Mb built-in Realtek HD)
Master Output Channels: Left & Right
Master Output Delay: 0 ms
Preview Output: No output
Sample Rate 44100
Buffer Size 512
External Audio FFT Input: No Input
Audio FFt Input Gain: 0.0dB ...

Hello,

I've been trying to sync up some effects etc. with music in the club where we run Resolume, and I noticed that the BPM counter always seems to run slower than its setting, e.g. BPM set to 120 BPM, but the counter only runs approximately 112 beats in a minute, 130 BPM setting counts off ...