does Evolution UC 16 / UC 33 work with resolume??

Stefan_ · Post by **Stefan_** » Sun Jun 01, 2003 14:10

Ey peeps, does anyone know if the Evolution UC 16 and UC 33 work well with Resolume??

cman_ · Post by **cman_** » Sun Jun 01, 2003 22:31

I use UC16, works good, but sometimes dont react correctly, the problem is to get zero value for example, also spaces among knobs are very small... would condider to buy some other model if I would go shop now...

nz_ · Post by **nz_** » Mon Jun 02, 2003 23:38

We use the evolution uc16 too. And I agree with cman. We bought it because we didn't have any budget yet and resolume needs midi-control. Did I gig last night, and it was hot! The knobs slipped everywhere (swetty hands

. they are to small, but then again good for starters. Something about not reacting correctly is due the overlay settings. Some overlay settings don't have slider control. changing the setting of a knob affects is such an overlay mode will end-up in strange results (incorrect ofset) when changing back to a slider controller overlay setting.

Perhaps you should ease on the booze cman during gigs,

jk

cheers
nz

nz_ · Post by **nz_** » Mon Jun 02, 2003 23:40

dyslectic or what

stefan_ · Post by **stefan_** » Tue Jun 03, 2003 00:17

Well i think i have to go to the shop for a demo and will check em out there.

Cman. , nz, thnx for the responce

cman_ · Post by **cman_** » Thu Jun 05, 2003 07:22

well... overlay settings... I use also Keyfax Phatboy and there is no such problem - also JekkylMcHyde from VJo forum have same troubles with UC16...

Phatboy has short durability of knobs... Doepfer Pocket Control looks reliably but is expensive... On the other hand work in Resolume with controller and without it is something absolutely different, so I wouldnt be scared to invest